Sartorius PMA.Vision VIS1X Notice D'installation page 120

Certificate No:
Date of Issue:
Manufacturer:
Additional Manufacturing
location(s):
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the
IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and
found to comply with the IECEx Quality system requirements. This certificate is granted subject to the conditions as set out in IECEx
Scheme Rules, IECEx 02 and Operational Documents as amended.
STANDARDS:
The electrical apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was
found to comply with the following standards:
IEC 60079-0 : 2011
Edition:6.0
IEC 60079-11 : 2011
Edition:6.0
This Certificate does not indicate compliance with electrical safety and performance requirements other than those expressly included in the
TEST & ASSESSMENT REPORTS:
A sample(s) of the equipment listed has successfully met the examination and test requirements as recorded in
Test Report:
GB/FME/ExTR16.0001/00
Quality Assessment Report:
GB/FME/QAR13.0002/01
120 Installation Instructions VIS1X
IECEx Certificate
IECEx FME 15.0007X
2016-03-09
Sartorius Lab Instruments GmbH & Co. KG
Weender Landstrasse 94 - 108
Goettingen 37075
Germany
Explosive atmospheres - Part 0: General requirements
Explosive atmospheres - Part 11: Equipment protection by intrinsic safety "i"
Standards listed above.
of Conformity
Issue No: 0
Page 2 of 3