Hilti PP 10 Mode D'emploi page 19

Symbols
Read the Return
operating materials for
instructions recycling
en
before use.
On the tool
DANGER
LASER RADIATION - AVOID DIRECT
EYE EXPOSURE
675-695nm < 5mW max.
CLASS IIIa LASER PRODUCT
Do not stare into the beam.
Laser warning plates for the USA in accordance with CFR
21 § 1040 (FDA).
On the tool
DANGER
LASER RADIATION - AVOID DIRECT
EYE EXPOSURE
520-550nm < 5mW max.
CLASS IIIa LASER PRODUCT
Do not stare into the beam.
Laser warning plates for the USA in accordance with CFR
21 § 1040 (FDA).
On the tool
3R
Laser warning plate in accordance with IEC825 /
EN60825-1:2003
Type identification plate
Made in Japan
Hilti= registered trademark of the Hilti Corporation, Schaan, Liechtenstein
DANGER
LASER RADIATION - AVOID DIRECT
EYE EXPOSURE
620-690nm < 5mW max.
CLASS IIIa LASER PRODUCT
Item No.: 319781
Date .:
PP 10
14
AVOID EXPOSURE
LASER LIGHT IS EMITTED
FROM THIS APERTURE
PP 10
3R
EN 60825-1:2003
This Laser Product
complies with 21CFR
1040 as applicable
Power: 6.0V=nom./250 mA
Type identification plate
AVOID EXPOSURE
LASER LIGHT IS EMITTED
FROM THIS APERTURE
Made in Japan
Hilti= registered trademark of the Hilti Corporation, Schaan, Liechtenstein
DANGER
LASER RADIATION - AVOID DIRECT
EYE EXPOSURE
520-550nm < 5mW max.
CLASS IIIa LASER PRODUCT
Item No.: 319791
Date .:
PP 11
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.:
PP 11
3R
EN 60825-1:2003
This Laser Product
complies with 21CFR
1040 as applicable
Power: 6.0V=nom./250 mA