Emission Levels; Technical Data; Machine Features; Intended Use - Festool RTSC 400 Li Notice D'utilisation D'origine

DTSC 400 Li, RTSC 400 Li
GB
– Do not open the battery pack or the charger!
– Prevent metal parts (e.g. metal chips) or fluids
from entering the charger!
– Do not use power adapters or battery packs
form other manufacturers to operate the cord-
less power tool. Do not use any charger from
other manufacturers for charging the battery
pack. The use of impermissible accessories may
result in electric shock and / or serious acci-
dents!
– Protect the battery pack from excessive heat > 50
°C or constant heat sources such as sunlight or
naked flames!
– Never use water to extinguish burning li-ion bat-
tery packs! Use sand or a fire blanket.
– Check the plug and the cable regularly and
should either become damaged, in order to avoid
a hazard, have them replaced by an authorised
after-sales service workshop.
– Always pull the mains plug out of the socket
when the charger is not in use.
2.4

Emission levels

Typically, the noise levels that are determined in ac-
cordance with EN 62841 (see EC declaration of con-
formity) are as follows:
Sound pressure level
L
PA
Noise level L
WA
Uncertainty K
4

Technical data

Cordless orbital sander
Voltage
No-load speed
Sanding stroke
Sanding pad
Weight (excl. battery pack, incl. sanding pad)
5

Machine features

On/Off switch
[1-1]
[1-2] Battery pack
Capacity display
[1-3]
14
DTSC 400Li RTSC 400Li
79 dB(A) 79 dB(A)
68 dB(A) 68 dB(A)
3 dB 3 dB
CAUTION
When working with noise
Damage to hearing
Always use ear protection.

Vibration emission value a
directions) and uncertainty K measured in accor-
dance with EN 62841 (see EU Declaration of Con-
formity):
Vibration emissions
value (triaxial) a
h
Uncertainty K
The specified emission values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary esti-
mates regarding vibration and noise loads during
operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with other
insertion tools or if not maintained adequately. Take
note of idling and downtimes of machine!
3

Intended use

The sanders are designed for sanding wood, plas-
tic, composites, paint/varnish, filler and similar
materials as directed. Metals and materials that
contain asbestos must not be processed.
To guarantee electrical safety, the machine must
not be damp or operated in a damp environment.
The machine must only be used for dry sanding.
The user is liable for improper or non-in-
tended use.
DTSC 400Li
18 - 20 V
6000 - 10000 rpm
2,0 mm
100 x 150 mm
0,9 kg
[1-4] Extractor connector
Speed control
[1-5]
Sanding pad
[1-6]
[1-7] Edge protector
(vector sum for three
h
DTSC 400Li RTSC 400Li
2
< 2.5 m/s 3 m/s
2
2 m/s 2 m/s
RTSC 400Li
18 - 20 V
6000 - 10000 rpm
2,0 mm
80 x 130 mm
0,9 kg
2
2