Warning Signal; Accessories - Festool RTSC 400 Li Notice D'utilisation D'origine

Loosen both ends of the edge protector.
Remove the edge protector by pulling it for-
wards.
8 Working with the machine
WARNING
Risk of injury
Always secure the workpiece in such a manner

that it cannot move while being machined.
Observe the following instructions:
– Do not overload the machine by pressing with ex-
cessive force! The best sanding results are
achieved with moderate application pressure.
The sanding capacity and quality are mainly de-
pendent on the selection of the correct abrasive.
– Work in corners and on edges tends to subject
the tip to increased stress and results in in-
creased heat development. In such cases, work
with reduced contact pressure.
– Hold the machine with one hand on the handle
[1-8].
8.1

Warning signal

The machine shuts down and makes a sound:
Switch off the machine.

Battery pack is empty.
Change the battery pack.

The machine shuts down and does not make a
sound:
Machine is overheated or has been overloaded.
Switch off the machine for 30 seconds.

Reduce the machine load.

If the machine's final speed is then not reached, al-
low the machine to cool down.
9 Service and maintenance
WARNING
Risk of injury, electric shock
When carrying out servicing and maintenance

work, always remove the batteries or the mains
adapter from the power tool first.
All maintenance and repair work which requires

the motor housing to be opened should always
be carried out by an authorised service work-
shop.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
Only use original Festool spare parts!
EKAT
4
Order No. at: www.festool.com/service
5
3
2
1
To ensure constant air circulation, always keep the
cooling air openings in the motor housing clean and
free of any obstruction.
In the event of a slowdown in performance or in-
creased vibrations, blow and clean cooling air
openings.
Keep the contacts on the machine, charger and

battery pack clean.
For service, maintenance, disposal and
transport of the battery pack, note enclosed
instructions of the battery pack!
10

Accessories

Use only original Festool sanding pads. Low-quality
sanding pads may cause serious machine imbal-
ance that decreases the quality of the working re-
sults and increases machine wear.
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
11 Environment
Do not dispose of electric power tools in house-
hold waste! Recycle devices, accessories and
packaging. Observe applicable country-specific
regulations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and im-
plementation in national law, used electric power
tools must be collected separately and handed in
for environmentally friendly recycling.
Information on REACh: www.festool.com/reach
Information on data protection
The power tool contains a chip which automatically
stores machine and operating data (RFID). This
data saved cannot be traced back directly to an in-
dividual.
DTSC 400 Li, RTSC 400 Li
GB
17