Dust Extraction - Festool RTSC 400 Li Notice D'utilisation D'origine

DTSC 400 Li, RTSC 400 Li
GB
Sanding work
– Sanding with max. abrasion
– Sanding off old paint
– Sanding of wood and veneered surface
prior to paintwork
– Intermediate sanding of paintwork on sur-
faces
– Sanding thinly applied undercoat
– Sanding wood with sanding cloth
– Edge breaking on wooden parts
– Smoothing primed wooden surfaces
– Sanding solid wood and veneered edges
– Sanding rebate of windows and doors
– Intermediate sanding of paintwork at edg-
es
– Light sanding of natural wood windows
using sanding cloth
– Smoothing wooden surfaces using sand-
ing cloth before staining
– Rubbing or removing excess limestone
residue using sanding cloth
– Intermediate sanding of paintwork on
stained surfaces
– Cleaning natural wood window rebate us-
ing sanding cloth
– Sanding stained edges
– Sanding of thermoplastics
7.2 Changing sanding pad [4a]
An optimal work result can only be achieved
using original accessories and consumables.
The use of non-original accessories or con-
sumables invalidates the right to claim under war-
ranty.
If the StickFix coating on the sanding pad has worn
out, the entire sanding pad can be replaced:
Undo the four screws.
Remove the sanding pad by pulling it down-
wards.
Attach the new sanding pad.
Use four screws to tighten it by hand (2.5 Nm).
7.3 Attaching sanding accessories using
StickFix [4b]
The suitable StickFix sandpaper and StickFix sand-
ing cloth can be attached quickly and simply to the
StickFix sanding pad.
16
Affix the self-adhesive sanding accessory to the

Adjusting
sanding pad.
wheel set-
7.4
ting
5 - 6
Dust hazard
Dust can be hazardous to health. Always work

with a dust extractor.
Always read applicable national regulations be-

fore extracting hazardous dust.
4 - 5
Integral dust extractor with long-life dust bag
As standard, the sanders are equipped with an inte-
gral dust extractor. The sanding dust is extracted
3 - 4
through extraction openings in the sanding pad and
is collected in the dust bag.
Installing the dust bag [5]
Slide the dust bag onto the machine until it
clicks into place.
If the suction power is decreasing, empty the
dust bag.
Press the dust bag onto the actuating elements.
Remove the dust bag by moving it towards the
rear.
2 - 3
Open the flap on the dust bag.
Empty the dust bag and dispose of the waste.
Dust extraction with Festool's mobile dust ex-
tractor
1 - 2
To prevent having to frequently empty the dust bag
when carrying out sanding work for a long period of
time, you can connect Festool's mobile dust ex-
tractor (with an extraction hose diameter of 27 mm)
to the extractor connection piece [1-4].
 The start-up mode switches the mobile dust ex-
tractor on as soon as you switch the orbital
sander on. The start-up mode only works in
conjunction with the mains adapter.
Recommendation: Use an antistatic suction hose.
This helps reduce the electric charge.
7.5
The edge protector [1-7] prevents the sanding pad
circumference from coming into contact with a sur-
face (e.g. when sanding along a wall or a window),
thus preventing back-kick of the machine, or ma-
chine damage.
Push the edge protector into the groove on the
machine.
Slot the two ends of the edge protector into
place until they click.

Dust extraction

WARNING
Edge protector [6]