Steba FGN 2.0 Mode D'emploi page 15

Anbau des Griffes am Frittierkorb
Preparing for deep fat frying
1)
Insert the heating element into both guide rails on the outer casing. Otherwise the
deep fat fryer will be prevented from starting up by the safety switch.
Place deep fat fryer on table, not against the wall, in a corner or beneath an extractor
hood.
Place oil that is suitable for deep fat frying into the deep fat fryer. However if the
overheat protection is activated anyway, switch off, press the „Reset" button on the
back of the electrical part with a 5mm diameter pen (e.g. tip of a ballpoint pen). Then
allow the heating element to cool for a while and remove it from the guide rail on
the outer casing. The overheating protection activates if the amount of fat in the de-
3)
vice is below the minimum or the fat has become contaminated with too much food
(e.g. breadcrumbs).
Connect power cable to the power supply. Check filling level.
The MAX mark must not be exceeded, and filling level must not drop below the Min
mark. The heating element on the bottom of the container must always be covered
with oil or liquid fat.
Never operate the device without fat or with an insufficient amount of fat.
Make sure that there is enough fat in the appliance!
Attention! Do not allow water to get into the oil!
Anbau des Griffes am Frittierkorb
Assembly of the handle on the frying basket
1)
3)
DF 300, DF 282, DF 180, DF 100
4)
DF 300, DF 282, DF 180, DF 100
4)
2)
5)
2)
5)
15