Technical Data - Vetus FTR330/13 Instructions D'installation

Check the seal between lid and housing after
cleaning and re-assembling the strainer. An
improperly sealed lid will result in air sucked
in by the sea water pump of the engine which
again will result in overheating of the engine.
To prevent damage of the water strainer, dur-
ing frost in the winter time, either the water
must be drained or the installation must be
filled with anti-freeze.
Remove the hoses to drain the strainer; the
housing is not equipped with a drain plug.

Technical data

Material - housing
- strainer element
- lid
Weight
Max. ambient temp.
Max. water temp.
Max. pressure
Cooling water strainer model 330
Take care that during filling with anti-freeze
no anti-freeze is spilled into the waterway.
Anti-freeze is poisonous.
With plastic lid
: Polypropylene GF
: HD Polyethylene
: Styrol/Acrylnitrile SAN
: 0.45 kg (1 lb)
: 75 °C (167°F)
: 55 °C (131°F)
: 0.5 bar (50 kPa, 7 psi)
ENGLISH
With metal lid
Navidurin® (PA66-GF30)
HD Polyethylene
Aluminium + Polycarbonate
1.5 kg (3.3 lb)
75 °C (167°F)
55 °C (131°F)
3 bar (300 kPa, 44 psi)
030502.02
5