Sony MZ-B50 Mode D'emploi page 9

3
Select the recording mode.
REC MODE
4
Record an MD.
built-in
microphones
xSTOP
Connect
firmly
to i
zREC
Connect firmly
To monitor the sound during recording.
Connect the supplied headphones/earphones with remote control to the i jack. You can adjust the
volume by turning the VOL control. This adjustment does not affect the recording level since the level
is adjusted automatically.
To
Record partway through the
previous recording
1)
Pause
1
Slide REC MODE to STEREO.
When you set the REC MODE switch to MONO, the
recording will be in monaural, but the recording time
will be two times longer than in stereo.
Make sure not to switch the recording mode while
recording.
REC
indicator
x
to i
Press
NPLAY, >CUE/AMS or .REVIEW/AMS
to find the beginning of the material to be recorded,
press XPAUSE, and then press zREC. The
recorder changes to recording pause. Press
XPAUSE again to start recording.
XPAUSE while recording.
Press XPAUSE again to resume recording.
1
Press zREC.
"REC" and "STEREO" appears, REC
indicator lights up, and then recording
starts.
You can monitor the recording
conditions, such as the recording
position, through the display or the REC
indicator (page 20).
If the disc is blank, the recording
starts from the beginning. If the
disc is partially recorded, the
recording automatically starts
from the end of the existing
material.
To stop recording, press xSTOP.
After you press the xSTOP button, the
recorder will automatically turn off in about 30
seconds.
9
-GB