To Start/Stop Recording In Sync With The Source Player (Synchro-Recording) - Sony MZ-B50 Mode D'emploi

To start/stop recording
in sync with the source
player
(Synchro-recording)
You can easily make digital recordings of
a digital source on an MD.
Before synchro-recording, make
connections to the digital source with a
digital cable, and insert a recordable MD.
CD players,
etc.
SYNCHRO REC
OFF
1
Slide REC MODE to STEREO.
2
Slide SYNCHRO REC to ON.
"SYNC" appears in the display.
E nd ¢¢7
Synchro-recording indication
"SYNC" doesn't appear if optical
cable is not connected to the LINE IN
(OPTICAL) jack on the recorder.
3
Press zREC.
The recorder stands by for recording.
18
-GB
REC MODE
zREC
ON
4
Play the source sound.
The recorder starts recording when it
receives the playing sound.
To stop recording, press xSTOP.
z
• When you record in monaural, you can record
twice as much as in stereo (page 19).
• You cannot pause manually during synchro-
recording.
• When there is no sound from the player for
more than 3 seconds during synchro-
recording, the recorder goes into the standby
mode automatically. When the sound comes
from the player again, the recorder resumes
synchro-recording. If the recorder is kept in
the standby mode for 5 minutes or longer, the
recorder stops automatically.
Notes
• Do not switch the SYNCHRO REC switch
after step 4. Recording may not be done
properly.
• The REC MODE setting cannot be changed
during synchro-recording.
• Even when there is no recorded sound on the
sound source, there may be cases when
recording does not pause automatically during
synchro-recording due to the noise level
emitted from the sound source.
• If a silent portion is encountered for 2 seconds
or more during synchro-recording, a new track
mark is automatically added at the point
where the silent portion ends.
• Synchro-recording cannot be done if the
connecting cord is not an optical cable, or if
the cable is connected to the MIC (PLUG IN
POWER) jack.