Cleaning; Cleaning The Heat Pump; Inspection - Steinbach BP-39WS-B Mini Mode D'emploi

2. Loosen the hose clamps
3. Pull the end of the hose off the adapter
When removing the end of the water hose, hold it with the opening facing upwards to prevent
uncontrolled spilling of the remaining water present in the hose.
4. Unscrew the end of the hose from the adapter
When removing the end of the water hose, hold it with the opening facing upwards to prevent
uncontrolled spilling of the remaining water present in the hose.
The water lines have been disconnected.

Cleaning

NOTE!
Risk of damage due to improper cleaning!
Improper cleaning can result in damage to the device.
- Clean the surface of the device with clear water after every use.
- Do not use any aggressive cleaning agents.
- Do not use any sharp or metallic objects such as knives, hard putty knives
or the like.
- Do not use any cleaning brushes.
- Do not use a high-pressure cleaner.

Cleaning the heat pump

1. Clean the housing and the grille of the fan
2. Clean the fins of the finned heat exchanger
air if necessary.
The fins are extremely sensitive and must not be touched!
3. Remove any deposits in the drain connection
unimpeded.
4. Dry off the heat pump with a dry cloth.
The heat pump is now clean.

Inspection

Check the following before every use:
- Is there evidence of damage to the device?
- Is there evidence of damage to the controls?
- Are the accessories in proper condition?
- Are the supply lines and wiring in proper condition?
- Are the ventilation openings free and clean?
Do not put a damaged device or accessory into operation. Have it inspected and repaired by the
manufacturer, the manufacturer's customer service or a qualified specialist.
42
3 of the adapters 2
2 on the inlet water connection
9
10
.
2 on the inlet water connection
with a slightly damp cloth.
carefully with a vacuum cleaner or compressed
4 so that condensation water can drain
7 .
6 .