Displaying Or Setting Parameters; Deinstallation; Disconnecting The Supply Lines - Steinbach BP-39WS-B Mini Mode D'emploi

Setting the desired water temperature
1. Repeatedly press the
The display shows the desired water temperature in °C.
14
The heat pump does not work if the set desired water temperature is below the
measured current water temperature.

Displaying or setting parameters

The heat pump has 11 parameters which can be shown or set via the display
"Parameters").
Displaying the parameters
1. Press and hold the SET button
The display
14
2. Press the Up 16
The display
14
3. Press the SET button
The value of the selected parameter blinks on the display
Setting the parameters
1. Press the Up 16
The desired value of the selected parameter blinks on the display
2. Press the SET button 18.
The desired value of the selected parameter is now set.

Deinstallation

CAUTION!
Risk of injury when moving heavy equipment!
The device is heavy! Incorrect lifting or uncontrolled tipping of the device can
result in injuries or damage to the device.
- Only lift, carry or tip the device with two people, never alone.
- Pay attention to maintaining proper posture (straight back, secure footing,
etc.).
- Use transport aids (e.g. pallet truck, or creeper dolly).
- Wear protective equipment such as safety footwear or gloves.

Disconnecting the supply lines

Disconnecting the electrical
1. Put the heat pump into the Standby mode (see the chapter on "Display").
2. Press the RESET button 12.
3. Disconnect the RCD adapter
The heat pump is now disconnected from the electrical supply.
Disconnecting the water lines
1. Switch off the water treatment pump.
Up16 or Down17
18
shows "A".
or Down 17 button repeatedly.
shows the selected parameter (A, B, C, 1-8; see "Parameters").
18 to select the required parameter.
or Down 17 button repeatedly.
C from the electrical supply.
button.
for 5 seconds while the heat pump is in the Operate mode.
.
14
.
14
D (see
41