4. INSTALLATION AND ADJUSTMENT
4.1 PRELIMINARY INFORMATION
• Keep the Instruction Manual and give it to the
next owner of the appliance.
• Check the appliance before installation for any
visible damage. Do not install or use any dam-
aged appliance.
• The appliance need to be installed with sufficient
4.2 WORKING PRINCIPLE OF THE APPLIANCE
The appliance is heated by natural gas or LPG. In
case flame on heating elements is out due to any
reason, there is a safety valve switching off gas
automatically. The Doner kebab skewer is rotated
4.3 MOUNTING AND CONNECTION
• Make electrical connection of your appliance in
accordance with the circuit diagram on page 14.
EN
• The appliance must be earthed in compliance
with the EN 60335-1 standard. Ensure mainte-
nance of the earthing on a regular basis.
• Electrical safety of the appliance may be ensured
only by means of a protected cable system in ac-
cordance with relevant regulations. It is very im-
portant to ensure this essential safety measure.
If in any doubt, have the installation checked by a
professional electrician. The manufacturer shall
not be liable for any damage that may arise from
a missing or broken fuse cable.
• When performing the electric connection of the
appliance, never use an extension cord. Appli-
ance safety cannot be ensured when an exten-
sion cord is used.
• Do not use your appliance in a multi-plug socket
outlet.
• Check the appliance before installation for any
visible damage. Do not install or use any dam-
aged appliance.
6
ventilation to prevent the occurrence of unac-
ceptable concentrations of substances harmful
to health in the room in which they are installed.
• Leave about at least 20 cm between the ap-
pliance and the adjacent walls for ventilation
purposes.
by a double-direction reversible AC motor. Doner
kebab meat is closed up by moving the upper and
lower-skewer locking mechanisms.
• Before connection of your appliance to the
mains, make sure that the data on the manufac-
turer's name plate complies with the data of your
local main circuit (voltage, frequency, safety de-
vices). If in any doubt, please consult a qualified
electrician.
• In order to avoid hazards, if the main cord is dam-
aged, it must be replaced by the manufacturer,
technical service authorised by the manufacturer
or a similarly qualified professional.
• Before performing a gas connection of the appli-
ance, check if local gas distribution requirements
(type and pressure of the gas) and adjustment of
the appliance are appropriate.
• Ensure that the gas connection of the appliance
is done in accordance with valid standards.
• During installation, never squeeze the gas hose
under the frame.
• Keep the gas hose away from heated parts of the
product.
• Connect your appliance to the LPG tube or the
natural gas supply valve as close as possible. The
connection must be leak-proof.