Location Requirements; Product Dimensions - Single Ovens - Whirlpool WOS97ES0ES Instructions D'installation

Masquer les pouces

Table des Matières

Les langues disponibles

IMPORTANT: Observe all governing codes and ordinances.

C abinet opening dimensions that are shown must be used.

■

Given dimensions provide minimum clearance with oven.

R ecessed installation area must provide complete

■

enclosure around the recessed portion of the oven.

G rounded electrical supply is required. See "Electrical

■

Requirements" section.

E lectrical supply junction box should be located 3"

■

(7.6 cm) maximum below the support surface when the

oven is installed in a wall cabinet. A 1" (2.5 cm) minimum

diameter hole should have been drilled in the right rear or

left rear corner of the support surface to pass the appliance

cable through to the junction box.

NOTE: For undercounter installation, it is recommended

that the junction box be located in the adjacent right or left

cabinet. If you are installing the junction box on rear wall

behind oven, it is recommended that the junction box be

recessed and located in the upper center of the cabinet.

O ven support surface must be solid, level, and flush with

■

bottom of cabinet cutout.

Floor must be able to support a single oven weight of

■

154 lbs (70 kg).

Floor must be able to support a double oven weight of

■

288 lbs (131 kg).

IMPORTANT: To avoid damage to your cabinets, check

with your builder or cabinet supplier to make sure that

the materials used will not discolor, delaminate, or sustain

other damage. This oven has been designed in accordance

with the requirements of UL and CSA International and

complies with the maximum allowable wood cabinet

temperatures of 194°F (90°C).