Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
DANGER
WARNING
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
P hillips screwdriver
■
M easuring tape
■
H and or electric drill (for wall cabinet installations)
■
1 " (2.5 cm) drill bit (for wall cabinet installations)
■
L evel
■
F lat-blade screwdriver
■
Parts Needed
U L-listed or CSA-approved conduit connector
■
U L-listed wire connectors
■
W arming Drawer Deflector Kit (for ovens installed above
■
a warming drawer)
Order Part Number W10536339 for stainless steel 30"
(76.2 cm) kit
To order, see the "Assistance or Service" section of the
Use and Care Guide.
F lush Installation Kit (for Single and Double installed
■
at flush installation)
Order Part Number W10752683A for stainless steel
30" (76.2 cm) kit
To order, see the "Assistance or Service" section of
the Use and Care Guide.
2
BUILT-IN OVEN SAFETY
Your safety and the safety of others are very important.
INSTALLATION REQUIREMENTS
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow
instructions.
Tools and Parts
Parts Supplied
#8-14 x 1" screws – single ovens (2), double ovens (4)
■
#8-18 x ³⁄
■
#8-18 x 1/4" screws – bottom vent trim (4)
■
#8-18 x ³⁄
■
Bottom vent
■
Bottom vent trim
■
Rear feet – double oven (2)
■
Front feet – double oven (2)
■
Foam strip – single oven*
■
Check local codes. Check existing electrical supply.
See "Electrical Requirements."
It is recommended that all electrical connections be made
by a licensed, qualified electrical installer.
*Foam strip not included with double oven.
" screws – bottom vent (2)
8
" screws – double oven feet (4)
8
Publicité
Table des Matières
