Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. At a 45° angle, align door hinges with slots in the lower
front of the oven cavity. Slowly insert door, making sure
you maintain the 45° angle. You will know the door is
engaged in the slot when you feel a slight drop.
4. Lower the oven door to the fully open position. If the oven
door does not open to a full 90°, repeat steps 1 through 3.
5. Locate the oven door hinge locks in the corners of the oven
door, and rotate the hinge locks toward the oven cavity to
the locked position.
See Step 3 (illustration A) in the "Remove Oven Door(s)"
section for proper locked position.
6. Close the oven door.
7. When the hinges are properly installed and the door closed,
there should be an even gap between the door and the
control panel. If one side of the oven door is hanging
lower than the other, the hinge on that side is not properly
installed.
8
Positioning Oven Feet for Multiple Cabinet
Cutout Heights
Single Ovens
The positioning of the oven feet allow a single oven to be
installed in a cutout height between 26
(68.4 cm and 74.8 cm). Refer to the following instructions
to position the feet for the size of your cabinet cutout.
Cutout Height is Between 27
and 72.7 cm)
The oven feet do not need to be changed. They are positioned
correctly as received.
Go to the "Make Electrical Connection" section.
⁄
" and 29
⁄
"
15
7
16
16
⁄
" and 28
⁄
" (70.2 cm
5
5
8
8
Publicité
Table des Matières
