Symbols Used; Operating Instructions; Taking Into Operation - Truma S 3004 P Mode D'emploi

Automatic ignitor retrofit kit S 3004 P

Symbols used

Symbol indicates a possible hazard.
Risk of burns! Hot surface.
Comment including information and tips.
Observe the ESD-regulations!

Operating instructions

Pay attention to the enclosed instructions for use and the
important operating information before commissioning
the heater! The vehicle owner is responsible for operation of
the device taking place correctly.

Taking into operation

Make sure that a battery is inserted before commissioning for
the first time (see "Battery change on auto ignitor")!
1. Open gas cylinder and quick-acting valve in the gas supply line.
2. Turn the control knob (a) into thermostat position 1 – 5 and
push down far as possible. Ignition takes place automatically
(audible ignition) until the flame burns.
0
1
5
4
2
3
Hold down the control knob for up to 10 seconds so that the
safety pilot responds.
Wait min. 3 minutes before re-igniting after a
fault, otherwise there is the risk of deflagration!
O
5
a
1
4
2
3
9