Technical Data - FUST NOVAMATIC KS196.2-IB Notice D'utilisation

9. Remove the hinge. Put over the pin in
the direction of the arrow. Install the
hinge on the opposite side.
10. Tighten the hinge.
11. Put the top in position.
12. Push front the top.
13. Screw both screws on the rear side.
14. Remove and install the handle on the
opposite side.
1
CAUTION! Reposition, level the
appliance, wait for at least four
hours and then connect it to the
power socket.

TECHNICAL DATA

Technical data
Height
Width
Electrical connection
• Before plugging in, ensure that the
• The appliance must be earthed. The
2
3
• The manufacturer declines all
• This appliance complies with the E.E.C.
mm
mm
Do a final check to make sure
that:
• All screws are tightened.
• The magnetic seal adheres to
the cabinet.
• The door opens and closes
correctly.
If the ambient temperature is
cold (i.e. in Winter), the gasket
may not fit perfectly to the
cabinet. In that case, wait for the
natural fitting of the gasket.
In case you do not want to carry
out the above mentioned
operations, contact the nearest
Authorised Service Centre. The
Authorised Service specialist will
carry out the reversibility of the
doors at your cost.
voltage and frequency shown on the
rating plate correspond to your domestic
power supply.
power supply cable plug is provided with
a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a qualified
electrician.
responsibility if the above safety
precautions are not observed.
Directives.
1050
550
54