Intended Use - VOLTCRAFT VC-750E Mode D'emploi

3. Intended use

Measures and displays electrical parameters in measurement category CAT IV (up to 600V). Complies with the
EN 61010-1 standard and all lower categories.
The product supports measurement and testing of:
• Measures DC voltages up to 600 V (10 MΩ impedance)
• Measures AC voltages up to 600 V (10 MΩ impedance)
• Measures AC voltages up to 600 V with a low impedance (300 kΩ)
• Measures direct and alternating currents up to 2000 µA (signal currents)
• Contactless measurement of direct and alternating currents up to 600 A
• Frequency measurement:
- Electronic: 10 Hz – 40 MHz (max. 30 Vrms)
- Electrical: 40 – 400 Hz (30 – 600 Vrms)
• Duty cycle
• Measures capacitance up to 60 mF
• Measures resistance up to 60 MΩ
• Measures temperatures from -40 to +1000 °C.
• Continuity test (<10 Ω acoustic)
• Diode test
• 3-phase rotation indicator for the voltage range 80–600 V/AC
• Low pass filter (600 V)
• Split display for voltage/current
• AC + DC Current/Voltage
Use the control knob to select the measuring mode.
Effective (True RMS) measurements are displayed when measuring AC voltages/currents with a frequency of up to
400 Hz.
The µA current measurement input is protected against overload by a resettable fuse (PTR). The voltage in the
measuring circuit may not exceed 600 V.
The device switches off automatically after 15 minutes if no buttons are pressed. This prevents the battery from
draining. This automatic switch-off function can be disabled.
Do not use the multimeter when the battery compartment is open.
The multimeter has an IP54 protection rating, meaning that it is dust and splash-proof. However, do not use the
multimeter when it is wet or damp.
Do not take measurements in potentially explosive areas, damp rooms or adverse environmental conditions. Adverse
conditions include: Moisture or high humidity, dust and flammable gases, vapours or solvents, thunderstorms, and
strong electromagnetic fields.
For safety reasons, only use test leads and accessories that conform to the multimeter specifications.
42