Introduction; Product Description - VOLTCRAFT VC-750E Mode D'emploi

1. Introduction

Dear customer,
Thank you for purchasing this product.
This product complies with statutory national and European regulations.
For safety reasons, always follow the instructions in this manual.
These operating instructions are part of this product. They contain important information on setting up and
using the product. Please consider this if you pass on the product to a third party, and keep the operating
instructions for future reference.
If there are any technical questions, please contact:
International:
United Kingdom:

2. Product description

The multimeter displays measurements on a digital display. The multimeter has 6000 counts (count = smallest display
value). The true RMS value is used when measuring AC voltages and currents.
To prolong the battery life, the multimeter switches off automatically after 15 minutes of inactivity. The automatic
switch-off function can be manually disabled.
The meter can be used for DIY, professional, and industrial purposes up to CAT IV. The rubber seal gives the
multimeter a robust design and enables it to withstand falls from up to 2 m. The multimeter is also dust and splash-
proof (IP54). Before replacing the batteries or fuse, check that the battery compartment seal is clean and intact.
Remove dirt and dust with a thin cotton swab. The seal must not be damaged. Do not apply grease or other sealants,
as this may affect the safety of the device.
Protective caps may be attached to the test lead plugs. Remove these before inserting the test leads into the
multimeter.
www.conrad.com/contact
www.conrad-electronic.co.uk/contact
41