Installation Instructions - F.Bertazzoni Professional Série Instructions D'installation Et D'utilisation

/ Introduction
INTRODUCTION
INSTRUCTIONS FOR USE
• Take great care when cooking food with a high
alcohol content, as this could cause a fi re.
• Remove any food residue from inside the oven
before using the appliance in order to prevent
fi res and smoking.
EN
• Do not place any objects or baking paper on
the bottom of the oven.
• After cooking, keep the door closed while the
oven is cooling down to prevent damaging
adjacent kitchen units.
• Fruit juice can cause indelible staining; use
deep dishes to prevent leakage.
• Damaged containers, or those which are
unsuitably small, can lead to serious injuries.
• When opening the oven door, be very careful
of escaping steam: burn hazard!
• Do not pour water into a hot oven: this would
create steam, and thus a burn hazard!
• Keep the door seal clean to prevent heat
escaping and damaging adjacent units.
• Insert oven racks and trays all the way into
their guides to prevent damage to the door
when closing.

INSTALLATION INSTRUCTIONS

THIS APPLIANCE MUST NOT BE INSTALLED
IN BOATS OR CARAVANS
The appliance must not be installed on a
pedestal.
• Position the appliance into the carcase with
the help of a second person.
• To prevent overheating, the appliance must
not be installed behind
a decorative door or panel.
• Gas appliances must only be connected up
and worked on by qualifi ed gas engineers,
who must be licensed and registered in most
jurisdictions.
• When connecting up the gas hose, this must
not exceed the maximum length provided for
by regulations.
• Pipes and hoses must not come into contact
with moving parts and must not be crushed or
pinched.
• Where required, use a pressure regulator
meeting the appropriate standards and
regulations.
• Check the tightness of the gas connections
after all work.
6
• On completing installation, check for any
leaks with a soapy solution, never with a
fl ame.
• Have installation and servicing carried out
by qualifi ed personnel in compliance with
applicable standards and legislation.
• The electrical connection must be made by
a qualifi ed electrician.
• Earthing is mandatory, in accordance with
local electrical codes.
• Use fl ex rated to support temperatures of at
least 90 °C.
• If the power supply cable is damaged,
contact technical support immediately and
they will arrange for it to be replaced.
• Always wear the appropriate PPE when
performing any work on the appliance
(installation, maintenance, positioning or
moving it).
• Shut off the main gas supply and isolate the
relevant electrical circuit before carrying out
any work.