SCHOLTES SOTC1410B Manuel D'utilisation page 48

3.3 Cleaning and initialization
Note : Operate the drawer empty.
A display test is carried out for 10 s after installation of the device and after a power
failure. The fan turns on at the same time.
The device should not be used during this period.
Remove all stickers and protective films.
Remove the non-slip mat and, if applicable, the drawer grid, and clean them both with
a sponge, hot water and a little washing up liquid. Dry with a soft cloth.
Wipe the inside and outside of the device only with a damp cloth, then dry it with a soft
cloth.
Put the non-slip mat and the grid (if applicable) back into the drawer. Then heat the
empty drawer for at least two hours.
Turn on the device by pressing the touch button
Press the touch button
Press the touch button
Press the touch button
Close the drawer.
Note :
The warming drawer has a soft automatic closing mechanism.
It also has a switch to ensure that the heater and the fan of the appliance only work
when the drawer is closed.
Metal components have a protective coating that may emit a slight odor when heated
for the first time.
The odor and any vapors will dissipate after a short time and do not indicate that the
appliance is defective.
Make sure that the kitchen is well ventilated when the appliance is on when the
appliance is operating for the first time for the first time.
The appliance can be used to keep food hot while heating plates and dishes.
However the food must be properly covered.
several times until the LED lights up.
several times until the rightmost LED lights up.
several times until «2 hrs» light up.
47
.