Hopper Hydraulic Lifting System Oil Level Check; Drive System Oil Level Check - Nilfisk FLOORTEC R 680 P Manuel D'utilisation

HOPPER HYDRAULIC LIFTING SYSTEM OIL
LEVEL CHECK
WARNING!
This procedure must be performed with the
hopper (4) fully retracted (as shown in the fi gure).
1. Engage the parking brake with the pedal (82) and the lever
(75).
2. Turn the ignition key (69) to "0".
3. Open the hood (23) and fasten it with the support rod (55).
4. Check that the oil level in the tank (41) is between the
minimum (MIN) and maximum (MAX) marks shown in Fig.
25.
5. If necessary, add oil through the plug (A, Fig. 25), using
the oil specifi ed in Technical Data paragraph.
6. Remove the support rod (55) and close the hood (23).

DRIVE SYSTEM OIL LEVEL CHECK

1. Engage the parking brake with the pedal (82) and the lever
(75).
2. Turn the ignition key (69) to "0".
3. Open the hood (23) and fasten it with the support rod (55).
4. Check that the oil level in the tank (28) is between the
minimum (MIN) and maximum (MAX) marks shown in Fig.
26.
5. If necessary, add engine oil SAE 10 W 40 through the plug
(A, Fig. 26).
6. Remove the support rod (55) and close the hood (23).
1463514000(1)2008-05 A
USER MANUAL
Figure 25
MAX
MIN
Figure 26
FLOORTEC R 680 P
ENGLISH
P100238
A
P100239
27