Side Broom Replacement - Nilfisk FLOORTEC R 680 P Manuel D'utilisation

SIDE BROOM REPLACEMENT

NOTE
Brooms with harder or softer bristles are available. This procedure is applicable to all types of brooms.
WARNING!
It is advisable to wear protective gloves when replacing the side broom because there can be sharp debris
between the bristles.
1. Drive the machine on a level fl oor and engage the parking brake with the pedal (82) and the lever (75).
2. Turn the ignition key (69) to "0".
3. Lift the side broom which has to be removed, with the lever (77) or (78).
4. Remove the screw (A, Fig. 11) inside the side broom, then remove the side broom (B) with the hub (B) by disengaging it from
the shaft (C).
Recover the key (D) and the washer (E).
5. At the workbench, remove the two screws (F, Fig. 11) and separate the broom (H) from the hub (G).
6. Install the new side broom (H, Fig. 11) onto the hub (G), and tighten the screws (F).
7. Install the key (D), then install the new side broom with the hub (B, Fig. 11). Install the washer (E) and tighten the screw (A).
8. Check and adjust the side broom height as shown in the previous paragraph.
1463514000(1)2008-05 A
USER MANUAL
Figure 11
FLOORTEC R 680 P
ENGLISH
P100224
23