Additional Ports; Connection Jack For Vibrating Pillow And/Or Modules; Headset Port; Headphone Port - HumanTechnik FLASHTEL COMFORT 3 BT Mode D'emploi

Additional ports

Connection jack for vibrating pillow and/or modules

Your telephone is equipped with a connection jack for a vibrating pillow or other additional
signaling modules. You can take advantage of this option to signal an incoming call not only
with a very loud ring and the very bright flashing light, but also with an optionally available
vibrating pillow and/ or other module.
The following optional modules can be connected to the telephone:
- Vibrating pillow
- Flash module
- Switch module
- Acoustic module

Headset port

Standard headset port with a 2.5 mm jack.

Headphone port

3.5mm output for connecting headphones, an induction loop or such like.

Resetting the telephone to the factory settings

Setting the telephone to the default settings
1. Press . „Set Display" will be shown in the display.
2. Enter 0,4,2,2,0,0,0,1,1 over the keypad
3. Press . You hear a signal tone.
4. Disconnect the small PSU plug from the DC connection jack at the backside of the tele-
phone.
5. Please wait three seconds and reconnect the small PSU plug with the DC connection
jack.
6. The telephone is set to the default settings now.
Default settings:
One-touch dial keys:
Redial memory:
Calling number display memory (CLIP):
Telephone book:
Recall time:
Dialing mode:
Ring tone:
Keypad tones:
Volume:
50 Italiano
Empty
Empty
Empty
Empty
300 ms
Tone
2
Switched on
Level 4