Getting Started; Pack Content; Telephone Connection; Installing The Batteries - HumanTechnik FLASHTEL COMFORT 3 BT Mode D'emploi

Getting started

Pack content

Please check if all following components are included:
• Telephone base unit
• Telephone handset
• Handset cord
• Telephone cable
• 7.5V plug-in PSU
• Operating instructions
• Guarantee card
If any parts are missing please immediately contact your dealer or the manufacturer directly.

Telephone connection

1. Insert the handset cord (spiral-shaped cable) into the jack marked with a receiver symbol
on the left or right side of the base unit and into the handset.
2. Insert the smaller plug for the telephone cable into the "LINE" jack (back of the base
unit). Insert the larger plug into the socket for your telephone line.
3. Insert the plug-in mains adapter cable into the "DC 7.5V" jack. Plug the mains adapter
into a 230 V mains socket.
Warning!
Don't place the telephone close to televisions, VDUs, fans, etc. so as to minimize the risk of
interference. Don't place the telephone in direct sunlight or close to a source of heat. Only
use the original telephone cable or a comparable cable with an international configuration.

Installing the batteries

1. Remove the battery compartment cover
by unscrewing the screw and sliding the
cover off.
2. Insert 4 fresh AA size batteries while
ob serving the +/- polarity marks in the
battery compartment.
3. Replace the battery compartment cover
and secure it with the screw.
4. Connect the telephone cable to the wall
outlet for telephone.
Battery
compartment
cover
Batteries
Screw
Italiano 31