EUROM Table Lounge heater 3000 RVS Livret D'instructions page 27

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 Apply the soap solution to the whole system (from the gascylinder) , using a spray bottle,
brush or cloth. Give special care to the connections, under in the base of the heater.
 Open the gas supply. If there is a leak, you will see soap bubbles forming.
 If there is a leak, turn off the gas supply. Tighten the leaking component, switch on the gas
supply and check it again. If bubbles are still created, disconnect the gas cylinder and contact
your supplier.
 Make sure that there are no flames or sparks in the vicinity when you are carrying out the
leak test and do not smoke!
 If the gas hose signs of cracks, tears or other damage exhibits, it must be replaced by a new
pipe or a hose of the same length and equivalent quality.
GAS ODOUR
An odour is added to gas to ensure that leaks can be detected. Gas is heavier than air; try to
detect the odour just above ground level!
 Immediately shut the gas supply.
 Do not do anything that could lead to fire or a spark being created; this could ignite the gas.
Do not switch any electrical components on or off, do not use matches or lighters and do not
use your telephone.
 Keep everyone away from the source of gas and allow plenty of time for it to dissipate. Stay
out of the area during this process! If you continue to smell gas or are not sure of the
situation, always call the fire services.
USE
TURNING THE PATIO HEATER ON
 Turn the valve on the gas bottle to open.
 Push the control button in and turn to PILOT setting. Keep the button depressed for at least
45 seconds (around 60 seconds if you have attached a new gas bottle).
 While pressing the control button, press a couple of times on the red ignition button until the
pilot light goes on. Keep the control button depressed for another 30 seconds in order to
activate the thermocouple. You can now release the control button.If the flame will not ignite,
turn the control button to Off and wait 2 minutes before a new attempt to inflame will be
made.
Take immediate measures if you smell gas!
Always have gas leaks repaired by professionals!
- 27 -

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

32.304.7

Table des Matières