Setting Bass Sound Control; Setting Bass Compressor; Setting Bass Focus; Speaker Setup - Alpine IVA-D106 Mode D'emploi

Setting Bass Sound Control

Setting item : BASS SOUND CONT.
Touch [ ] of BASS SOUND CONT.
The Bass Sound Cont. screen appears.

Setting Bass Compressor

You can adjust the sound of low frequencies as desired.
Touch [ ] or [ ] of BASS COMP. to select the desired
mode.
Bass sound is emphasized more as the mode is sequentially
switched as MODE1 2
frequencies.
Select OFF when the setting is not necessary.
Touch [RETURN] to return to the previous screen.

Setting Bass Focus

Using the previously specified delay number (time difference) allows
you to set a time difference between the front-rear/left-right speakers.
Namely, it enables a time correction based on your preference. With an
initial delay of 0.05 ms for each of the 0 to 400 steps, audible time
correction can be achieved.
Set the delay number in the front and rear, and on the
right and left of the desired speaker by touching the
respective [ ] or [ ] button.
• Any setting in Bass Focus is applied in time correction, too.
• Touch [RETURN] to return to the previous screen.
54
-EN
3, offering you vivid low

Speaker Setup

Check the playable frequency range of the speakers (not including the
subwoofer) before performing this operation to verify whether the
speakers can play low frequencies (of about 80 Hz or less).
• Avoid stopping, pausing, switching the disc, cueing, fast-forwarding
or switching the audio channel of this unit while making this
adjustment. The setting is canceled if Decode mode is switched.
Setting item : SPEAKER SETUP
Select the speaker characteristic by touching [ ] or [ ]
of the desired speaker setting.
1
OFF* : When no speaker is connected.
When a speaker that cannot play low frequencies
SMALL:
(80 Hz or less) is connected.
2
LARGE* : When a speaker that can play low frequencies (80
Hz or less) is connected.
1
* It is not possible to set the front speakers to "OFF".
2
* If the front speakers are set to "SMALL", the rear and
center speakers cannot be set to "LARGE."
• The Subwoofer can be set only to ON/OFF.
• If the center speaker is turned "OFF," the center channel's audio
signals are added to the audio signals output from the front speakers.
• If you set the speaker response to "OFF," also set the speaker setting
to "OFF" (page 51).
• Perform the setup for all the speakers ("Front," "Center," "Rear"
and "Subwoofer"). If not, the sound may not be balanced.
• When center is set to "OFF", the setting is ineffective even if center
is set with this function.
• Through changing the settings on each speaker, a change in the
output of the other speakers may occur due to the setting
requirements.
• When using the PRO LOGIC II, if the rear speaker is set to
"LARGE", then there will be no output from the subwoofer.
• The PXA-H700 or PXA-H701 can be set according to the playable
frequency range of your speakers.

Setting of Dolby Digital

Setting item : MULTI CH SETUP
Touch [ ] of MULTI CH SETUP.
The MULTI CH SETUP display appears.
Set the items below as you desire.