Sound Setting; Adjusting Subwoofer Level/Bass Level/Treble Level/Balance (Between Left And Right)/ Fader (Between Front And Rear)/Defeat; Setting The Subwoofer Level; Setting The Bass Control - Alpine CDA-9886 Mode D'emploi

Sound Setting

Rotary encoder (AUDIO . LOUD)
SOURCE/
BAND
/ESC
Adjusting Subwoofer Level/Bass Level/
Treble Level/Balance (Between Left and
Right)/Fader (Between Front and Rear)/
Defeat
1
Press Rotary encoder (AUDIO) repeatedly to
choose the desired mode.
Each press changes the mode as follows:
SUBWOOFER* BASS
DEFEAT VOLUME
Subwoofer level: 0 ~ +15
Bass level: –7 ~ +7
Treble level: –7 ~ +7
Balance: L15 ~ R15
Fader: R15 ~ F15
Defeat: ON/OFF
Volume: 0 ~ 35
• If no operation is performed for 5 seconds after selecting the
SUBWOOFER, BASS, TREBLE, BALANCE, FADER, VOLUME or
DEFEAT mode, the unit automatically returns to normal mode.
* When the subwoofer mode is set to OFF, its level cannot be adjusted.
Refer to "Turning Subwoofer ON/OFF" (page 16).
2
Turn the Rotary encoder until the desired sound is
obtained in each mode.
By setting Defeat ON, previously adjusted settings of BASS
and TREBLE will return to the factory defaults.
• Depending on the connected devices, some functions and display
indications do not work.
14
-EN
/ENT
SOUND SETUP
TREBLE BALANCE FADER
SUBWOOFER

Setting the Subwoofer Level

You can change the Subwoofer Level to create your own tonal
preference.
1
Press SOUND SETUP to activate the Sound Setting
mode.
2
Turn the Rotary encoder to select the SUBW. Level
Adjustment mode, and then press
1
SUBW. Level* Bass*
SUBW. Level
3
Turn the Rotary encoder to select the desired
subwoofer level (0~+15).
• If no operation is performed for 15 seconds, the unit will return to
normal mode automatically.
1
* When the subwoofer mode is set to OFF, its level cannot be adjusted.
Refer to "Turning Subwoofer ON/OFF" (page 16).
The adjustment can also be made by pressing Rotary encoder
(AUDIO). Refer to "Adjusting Subwoofer Level/Bass Level/Treble
Level/Balance (Between Left and Right)/Fader (Between Front and
Rear)/Defeat" (page 14).
2
* The function is inoperable when DEFEAT is set to ON.

Setting the Bass Control

You can change the Bass Frequency emphasis to create your own tonal
preference.
1
Press SOUND SETUP to activate the Sound Setting
mode.
2
Turn the Rotary encoder to select the Bass
Adjustment mode, and then press
3
SUBW. Level* Bass*
Black Out SUBW. Level

Setting the Bass Center Frequency

3
-1 Press BAND to select the desired bass center
frequency.
80 Hz 100 Hz 200 Hz
Emphasizes the displayed bass frequency ranges.

Setting the Bass Bandwidth

3
-2 Press SOURCE/ to select the desired bass
bandwidth.
Q1 Q2
Changes the boosted bass bandwidth to wide or narrow. A
wider setting will boost a wide range of frequencies above
and below the center frequency. A narrower setting will
boost only frequencies near the center frequency.
/ENT.
2 2 2
Treble* HPF* Black Out
/ENT.
4 4 4
Treble* HPF*
60 Hz 80 Hz
Q3 Q4