Error Codes
Heating can be resumed after the causes of the following errors are eliminated.
Indication
Possible cause
■ There is water or objects on or around the control
panel.
■ Key is held longer than required.
Cookware not detected
■ No pan placed on the cooking zone.
■ The pan has been removed.
■ The pan is not in the correct position.
(See pages 16-17)
■ An incompatible pan is used. (See pages 18-19)
Small object on the cooking zone
■ Small metal objects (e.g. cutlery, utensils) are placed
on the cooking zone.
If the above conditions are not rectified,
the display and the main power will turn off.
40
EN-
Error Codes
The following errors can be cleared by pressing the key of the applicable cooking
zone.
Indication
Possible cause
The intake or exhaust vent are blocked. (See page 46)
Remove any blockages.
Empty pan on the cooking zone
■ An empty pan has been heated.
■ When deep/shallow frying, oil was preheated by
selecting the power level instead of Deep/Shallow
Frying Mode.
Use Deep/Shallow Frying Mode for heating up
a large amount of oil.
■ Incompatible cookware is used for Deep/Shallow
Frying Mode. (See pages 18-19)
■ The pan is not in the correct position. (See page 17)
■ More than 800 g of oil has been heated up.
■ Ingredients were added while preheating.
If you cannot resolve the above problems, or any
the service centre.
Turn off the main power switch and the circuit breaker. Contact the dealer you
purchased the appliance from or the service centre for assistance.
NOTE
■
During the warranty period, any repairs may only be performed by
service technicians authorised by the appliance manufacturer.
■
Unauthorised repairs may cause electric shock and short circuit; do
not attempt this yourself. Consult an authorised service technician.
■
Warranty claims that resulted from improper connection or use of
the appliance is not covered by the warranty. In such cases, the
costs of repair are borne by the user.
■
For the list of service centres, refer to the guarantee booklet.
error appears, contact
41
EN-