Flush-Fitting; Post-Installation Checklist - Panasonic KY-B926SL Mode D'emploi

Flush-fitting

KY-B926SL, KY-B925GL and KY-B915AL can be fitted flush when installing.
Installing the appliance as flush-fitting
■ Only suitable for installation on heat and water resistant worktops such as
marble, natural stone, solid wood (if cut out edges are sealed).
■ Mount onto other types of worktops only with the recommendation of the
worktop manufacturer.
■ Remove the cushion from the underside of the appliance before flush fitting.
■ The internal width of the base unit must be at least as wide as the internal
cut-out width for the hob. This is to ensure that the casing can be easily
removed for maintenance.
■ Before sealing in, test that the appliance works. Grout the perimeter using a
heat resistant silicone. Smooth the seal with a suitable finishing product.
Follow the silicone instructions and do not turn on the appliance until the
silicone is completely dry.
490
524
29
CAUTION
■ Please observe the diagrams for the cut-out dimensions in granite
and marble worktops.
■ Using unsuitable silicone may cause permanent colour changes
to marble worktops.
Uninstalling the appliance as flush-fitting
■
Disconnect the appliance from the mains.
■ Remove the silicone seal from the perimeter with a suitable tool.
■
Push the appliance upwards from below to remove it.
CAUTION
Do not try to remove the appliance by prying it out from above.
52
EN-
(measurement: mm)
R3
R3
17
870
5.5
904

Post-installation Checklist

Upon completing installation, check and mark off the following items.
Checklist
Appearance ■ Ensure that the appliance is not tilted.
■ Is the top plate clean?
Electrical ■ Is the power supply a single-phase (220-240 V ~), or a
work three-phase (380-415 V 3N~/ 380-415 V 2N~)?
■ Has the earth been installed?
■ Has the earth leakage circuit breaker been installed?
Electrical
1. Touch to turn on the main power.
testing
■ Does the main power light illuminate?
2. Touch the following keys to check function of each
cooking zone:
■ Left front
■ Left rear
■ Middle
■ Right front
■ Right rear
Do each cooking zone selector and
■ Make sure to turn off each cooking zone and the main power switch after
performing electrical testing.
■ Hand the Operating / Installation Instructions to the customer.
I hereby certify that installation has been completed.
Checked
KY-B926SL KY-B915AL
KY-B925GL KY-B915AB
flash?
Signature of installer
53
EN-