Use Of Dishwasher Salt - Pelgrim GVW546ONY Notice D'utilisation

Water hardness
°dH
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
Setting manually
The dishwasher is factory set at position
2.
1. Open the dishwasher door.
2. Remove the lower basket from the dish-
washer.
3. Turn the water hardness dial to position
1 or 2 (see chart).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at level 5.
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C , until the lights of func-
tion buttons A , B and C start flashing.
3. Press function button A , the lights of
function buttons B and C go off while the

Use of dishwasher salt

Warning!
Only use salt specifically designed for use in
dishwashers. All other types of salt not spe-
cifically designed for use in a dishwasher, es-
pecially table salt, will damage the water soft-
ener. Only fill with salt just before starting one
°TH mmol/l
51 - 64 5,1 - 6,4
40 - 50 4,0 - 5,0
33 - 39 3,3 - 3,9
26 - 32 2,6 - 3,2
19 - 25 1,9 - 2,5
7 - 18 0,7 - 1,8
< 7 < 0,7
Adjusting the water hardness setting
manually
2
2
2
1
1
1
1
light of function button A continues to
flash. Simultaneously the End indicator
light starts to flash and a sequence of in-
termittent audible signals are heard.
The current level is indicated by the num-
ber of flashes of the End indicator light
together with a sequence of intermittent
audible signals with a pause of a few sec-
onds.
Examples:
5 flashes / 5 intermittent audible signals -
pause - 5 flashes / 5 intermittent audible
signals - pause, etc. = level 5
6 flashes / 6 intermittent audible signals -
pause - 6 flashes / 6 intermittent audible
signals - pause, etc. = level 6
4. To change the level, press function but-
ton A . Each time the button is pressed
the level changes. (For the selection of the
new level see the chart).
Examples: If the current level is 5, by
pressing function button A once, level 6
is selected.
If the current level is 10, by pressing func-
tion button A once, level 1 is selected.
5. To memorize the operation, switch off the
dishwasher by pressing the On/Off but-
ton.
of the complete washing programmes. This
will prevent any grains of salt or salty water,
which may have been spilt, remaining on the
bottom of the machine for any period of time,
which may cause corrosion.
Use of
electronically
level 7
level 6
level 5
level 4
level 3
level 2
level 1
71
salt
yes
yes
yes
yes
yes
yes
no