Pelgrim GVW546ONY Notice D'utilisation page 82

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

82
Fault codes and malfunction
• continuous flashing of the light of the running
programme
• 1 flash of the End indicator light
• intermittent audible signal
The dishwasher does not fill with water
• continuous flashing of the light of the running
programme
• 2 flashes of the End indicator light
• intermittent audible signal
The dishwasher will not drain
• continuous flashing of the light of the running
programme
• 3 flashes of the End indicator light
• intermittent audible signal
Anti-flood device is activated
Malfunction
The programme does not start
Once these checks have been carried out
switch on the appliance and close the door.
The programme will continue from the point
at which it was interrupted.
If the malfunction or fault code reappears
contact your local Service Force Centre.
For other fault codes not described in the
above chart, please contact your local Serv-
ice Force Centre.
Contact your local Service Force Centre,
quoting the model (Mod.), product number
(PNC) and serial number (S.N.).
Possible cause and solution
• The water tap is blocked or furred with lime-
scale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the water inlet hose
is blocked.
Clean the filter.
• The water inlet hose has not been correctly laid
or it is kinked or squashed.
Check the water inlet hose connection.
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid
or it is kinked or squashed.
Check the water drain hose connection.
• Close the water tap and contact your local
Service Force Centre.
Possible cause and solution
• The dishwasher door has not been properly
closed.
Close the door.
• The main plug is not plugged in.
Insert the main plug
• The fuse has blown out in the household fuse
box.
Replace the fuse.
• Delay start has been set.
If dishes are to be washed immediately, cancel
the delay start.
This information can be found on the rating
plate located on the side of the dishwasher
door.
So that you always have these numbers at
hand, we recommend you to make a note of
them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Publicité

Table des Matières
loading

Table des Matières