Use; Salt, Rinse-Aid And Detergent - Pelgrim GVW845KOR Notice D'utilisation

Programme explanation
Symbol Suitable for...
Dishes ready for the next
washing programme.
Very dirty pans and
plates (no glassware).
Normally dirty pans and plates.
Washing normally dirty dishes
55 °C
immediately after use.
Washing slightly dirty dishes
immediately after use
max. 6 couverts.
Course of the programme
Short, cold rinse to prevent leftover food from
drying.
Warm prewash at 45 °C; washing programme
at 65 °C; 2 cold rinses and a warm rinse at 67 °C;
drying.
Rinse at 45 °C; washing programme at 65 °C;
1 cold rinse and a warm rinse at 67 °C, drying.
Cold rinse; washing programme at 55 °C;
1 cold rinse and a warm rinse at 55 °C; drying.
Short washing programme at 45 °C; 2 cold rinses
and a warm rinse at 67 °C; drying.

Salt, rinse-aid and detergent

Water softener
The dishwasher is equipped with an automatic
water softener which, if used with salt which is
suitable for dishwashing machines, extracts
hard constituents from the water.
Hard water leaves behind white spots on the dry
washing-up; moreover, the dishes and utensils
will become dull in the course of time, losing
their shine. The appliance can be adjusted in
accordance with the degree of hardness of the
tap water in your home and the related salt
consumption.
At the time of leaving the factory, the
machine is adjusted to an average degree of
hardness.
After you have topped it up with salt, make
care that you close the salt reservoir properly
again. It is important that neither the
detergent nor the washing water can flow
over into the reservoir, since that could have
a negative influence on the functioning of the
regeneration device. The guarantee does not
cover such a malfunction.
Topping-up the salt
Use only salt that is suitable for dishwashing
machines for household use. If you make use
of salt pellets, you must not fill the reservoir
completely.
Under no circumstances should you make use
of kitchen salt or industrial salt, since these
contain non-soluble constituents which, over
the course of time, can have a negative
influence on the functioning of the water-
softening device.
fig. 3
Add salt when the indicator light (fig. 2-D) on
the display comes on.
The salt reservoir is located at the bottom of
the dishwashing machine. After having first
removed the lower rack, unscrew the
reservoir cap in an anti-clockwise direction,
and pour in the salt, using the funnel (which is
supplied with the dishwashing machine) (fig. 3).
Remove any salt residue from the edge of the
reservoir opening before you screw the cap
closed again. The water-softener can contain
approximately 1.7 kg of salt.
During the first washing programme, also
pour 1 litre of water into the reservoir, along
with the salt.
The salt reservoir must always be filled
immediately before a washing programme. In
this way, the overflowing salt solution is
always removed simultaneously by the
washing-up water. The long-term presence of
salt solutions can cause corrosion of the
housing.