Safety Instructions For Grinding Tools; Operation; Switching On And Off; Releasing The Plunge Lock - Parkside PTS 500 A1 Instructions D'origine

Safety instructions for grinding tools

GB
IE a) General
Grinding tools are very fragile and likely to break
which is why great care must be taken when hand-
ling the grinding tools. Using damaged, incorrectly
clamped or incorrectly installed grinding discs is
dangerous and may cause serious injury.
b) Handling, transport and storage
Grinding tools are to be treated with care and
transported carefully. Grinding tools should be
stored in such a way that they are not exposed
to mechanical damage or harmful environmental
influences.
Avoid any risk of an electric shock.
■ Check the condition of the device, power cord
and power plug at regular intervals. Stop using
appliances where the aforementioned parts are
damaged. Never open the device. Damaged
appliances, power cords or power plugs cause
danger to life by electric shock. Have repairs
and replacement work done only by the Service
centre or a qualified electrician.
■ Do not operate the appliance if it is damp or in
a humid environment.
■ When working outdoors, connect the appliance
via a fault current circuit breaker with a max-
imum tripping current of 30 mA. Use only an
extension cord approved for outdoor use.
NOTE
► Always hold the power cord away from the
working area of the machine and run it to the
rear away from the machine.
10

Operation

Switching on and off
Switching on:
♦ Pull the ON / OFF switch
Switching off:
♦ Release the ON/OFF switch

Releasing the plunge lock

♦ Push the plunge lock
pressed.

Selecting the cutting depth

NOTE
► We generally recommend setting the cutting
depth to approx. 2 mm more than the
thickness of the material. This ensures that you
achieve a clean cut.
♦ Release the quick-release lever for setting the
cutting depth , and set the desired cutting
depth on the dial
7a
lease lever again.

Fitting the rip fence

♦ Loosen the rip fence screw
plate and insert the rip fence
rip fence slot . Tighten the screw

Handling the plunge saw

1. Place the machine on the material and switch
on, as described in the chapter "Switching on
and off".
2. If necessary, align the machine using the rip
fence or by using a marked line.
3. Saw by applying moderate pressure.
Types of saw blades:
The types of saw blades supplied cover the most
common fields of application.
back.
.
forward and keep it
and clamp the quick-re-
on the base
11a
into the
again.
11a
PTS 500 A1