Cleaning Floors; Switching On And Regulating The Steam Jet - Dirt Devil Aqua clean Mode D'emploi

02_DD302_gb.book Seite 48 Freitag, 17. April 2015 1:44 01

6 Cleaning floors

6.1 Switching on and regu-
6 Cleaning floors
lating the steam jet
ATTENTION:
Only use mains sockets with an electrical voltage which matches the voltage on the appliance's
type plate. Given the high power consumption of the appliance, only use mains sockets with an
earth contact and do not use extension cables or multiple-outlet power strips.
11
12
13
48
WARNING:
Risk of scalding! Never lay the appliance on its side dur-
ing operation. The appliance must not be used in a hori-
zontal position or upside down.
1. Check that the water tank has been filled, Chapter 3,
"Filling the water tank".
2. If you wish to add detergent to the steam when cleaning
the floor, set the detergent controller to "ON" (Fig. 11).
Check whether the detergent tank has been filled,
Chapter 4, "If you use detergents".
3. Fully unwind the power cord (Chapter 5.2, "Uncoiling
the power cord quickly") and secure it in the clip for se-
curing the power cord (Fig. 1/24).
4. Place a clean cleaning cloth on the floor so that its light
side is facing upwards.
5. Now place the steam base exactly on the cleaning cloth.
The cloth is thus attached to the appliance.
6. Plug the mains plug into a socket with an earth contact.
7. Switch the On/Off button for the steam jet (Fig. 12) to
the "ON" position.
- The appliance now heats up. The mains control light
(" ") lights up.
8. Wait for about 20 seconds.
- The steam ready indicator ("
9. Select the steam controller position which you think is
suitable for the surface you wish to clean (Fig. 13):
- "MIN": for sealed wooden floors and laminate
- middle position: for tiled floors
and for PVC and vinyl floors
- "MAX": for short-pile carpets and rugs
NOTE:
We recommend that you begin with the lowest level
("MIN") and slowly increase the steam jet with the steam
controller as required.
") lights up.