Hauff-Technik HSI 150-SEGMENTO Instructions De Montage page 13

HSI 150-SEGMENTO
Use the assignment template to determine the diameter of
3
the cables and select the appropriate segments based on this
information (see table under point 3, HSI150 -SEGMENTO).
Then clean the cables with cable cleaner.
Outside of building
4
Remove the blind plug from the coloured sealing segment.
Apply a thorough coating of GMS „SEGMENTO" lubricant
to the opening(s) of the sealing segment and cables.
Do not install the sealing segment yet.
Route the cable through the corresponding opening in the
5
HSI 150-S3 system cover. Then, slide the sealing segment
over the required length of routed cable and allow it to
click into place in the opening of the HSI 150-S3 system
cover on the outside of the building.
Use the Hauff DMS torque screwdriver to tighten the Allen
screws until the torque control triggers an acoustic and
mechanical signal (tightening torque 1.2 Nm).
Install other sealing segments according to points 3 - 5 and
6
push black screw-on cover caps onto the Allen screws.
Leave the blind plug in the sealing element if it is not
being used.
If cables are to be installed at a later date, remove
the corresponding sealing segment and carry out the
installation as described in points 3 - 5.
13
GB