Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER & PARTS MANUAL
20
Make sure the blades are
rotating or press the button
18)
(
of the control panel to
9
switch on your blades.
Make sure the moulding is
against the measurement
stop.
Release the pedal and
make sure the moulding is
hold firmly in place by the
clamps.
First, press the button (20)
and keep it pressed, then
pull down the right handle
to do the cut.
Adapt the mouvement to the type of material to be cut. Plastic must be cut in a fast motion whereas hard wood and
thick mouldings will require a slower movement. It is also advised to help the blades back movement, do not release
suddenly the handle which would result in a shock and vibrations which are not good for the quality of the cut and
the durability of the system. Keep the button (20) pressed during the complete cycle of the machine.
For your safety, releasing the button (20) while the right blade is not back up will stop the blade rotation.Press the
button (18) to restart the blades if needed.
If after a cut a piece of wood needs to be pushed out of the machine and is not accessible, do never introduce your
hands bellow the brushes. Push that piece using another piece of wood.
5.B.f
Cut of the first piece
16
17
9
9
Figure 5-17
Figure 5-19
18
Example
of
bad
positionning
of
the
moulding, the left clamp
9
will push the moulding
against the right blade
during the cut, causing
damage to the blade and
the moulding.
CS940
19
9
Figure 5-18
28
Publicité
Table des Matières
