Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER & PARTS MANUAL
When installing the machine, make sure the floor is flat and stable, make sure your floor can support the weight
of the machine.
The machine must be installed in a temperate environement with no excessive humidity. Select a position where
the light with be sufficient to light the working bench of the machine.
4.B
INSTALLATION OF THE ARMS
Allen key N.4 & N.5
Flat span of 10mm
The machine is delivered with its arms
profiles dismounted :
-
Right arm (8).
-
Left arm (7).
-
Right profile (6).
-
Left profile (PRG).
Pay attention, during
handling,
to
not
damaging the edge of
the scales which are
very fragile.
Remove the 2 screws
(V2) & (V3) and their
washers
from
the
inside
of
the
arm.
Discard the nut (V3)
that was just a spacer
for transport to avoid
damaging the scale.
4.B.a
Right arm installation
and
PRG
Figure 4-7
V2
V3
Figure 4-9
On the right side of
the machine, remove
the screw (V1) and its
locking nut. Keep that
screw to install it back
in the same position
later.
Unlock the 3 screws
(ULF) of 4 turns.
CS940
6
8
7
Figure 4-6
V1
Figure 4-8
Figure 4-10
17
Publicité
Table des Matières
