Cassese CS 940 Manuel D'utilisation page 21

USER & PARTS MANUAL
Lock the 3 screws
(ULF) from the top of
the profile.
Holding the arm, lock
the screws under it.
Lock the screws under
the left arm.
Install the washer and
nut on the screw (V6)
and lock the nut while
holding the screw with
an Allen key.
A hole will receive the
locking Allen key of
the blade, install in
this hole the key to
have it available
easlily.
Still holding the arm,
install the nut so they
are inside
track of the profile.
Figure 4-36
With the bubble level,
check the level of the
arm while locking the
front screw
following pictures).
Figure 4-38
Lock the screw (V6) in
the front
machine.
Figure 4-40
Remove the adhesive
protection under the
scale and stick it on
the table of the saw.
Figure 4-42
Figure 4-44
the the
(see
of the
CS940
Figure 4-37
Figure 4-39
Figure 4-41
Figure 4-43
21