Handling And Unpacking - Cassese CS 940 Manuel D'utilisation

USER & PARTS MANUAL

3 HANDLING AND UNPACKING

Flat screw driver.
Protecting gloves
To handle the machine, it
is necessary to use a
Forklift equiped with forks
of minimum 115cm lenght.
The weight of the machine
is 167kgs.
Locate the front facing of
the crate, it is hold in place
by special ears that can be
bent back to open the
door.
Cut the straps closing the
crate and remove the top
cover and top belt (BT).
Take care of not
damaging the profiles
which are stored at the
back of the saw, remove
them before introducing
the forks under the
machine.
Pay attention not to
damage the scales that
are protuding from top of
the arm. They are very
fragile.
Cut the schrink wrap film to
extract the arms of the
machine.
BT
Figure 3-1
Figure 3-3
Figure 3-5
Crowbar
Forklift
With the help of a flat
screw driver, bent back the
ears to be able to remove
the front panel of the crate.
Pull on the front facing to
open it.
With the help of the
crowbar, remove the side
panels of the crate.
You can then lift the
machine using the forklift.
Insert the forks at the
indicated place in picture
opposite.
CS940
Figure 3-2
Figure 3-4
Figure 3-6
15