Cassese CS 940 Manuel D'utilisation page 18

USER & PARTS MANUAL
Unlock the 2
horizontal screws of 4
turns (see picture
opposite). If needed
use the flat span of
10mm to hold the nut
at the extremity of the
screw.
With the help of a
second person holding
the arm, install back
the (V1) screw that
was dismounted in
Figure 4-12. Do not
block the screw yet.
Unlock the 3 screws
under the right arm of
4 turns.
Slide the profile to
center of the saw,
paying attention that
the (ULF) screws are
sliding gently in the
bottom track of the
profile.
Lock the 3 screws
(ULF).
Start to install the right
arm (8), taking care of
not damaging
extremity of the scale.
Figure 4-11
Still with the help of
the second person to
hold the arm, put back
the screws (V2) and
(V3), do not block
them.
Figure 4-13
Slide the right arm
profile (6)
screw as shown in
the picture opposite.
Figure 4-15
Slide the profile until
the stop nut (B) is
reached.
Figure 4-17
Lock the 2 horizontal
screws back.
Figure 4-19
the
in the
CS940
Figure 4-12
Figure 4-14
Figure 4-16
B
Figure 4-18
Figure 4-20
18