Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER & PARTS MANUAL
5.B
SAWING
Press on the pedal to
release the clamps and to
be able to introduce the
moulding
inside
the
machine. Keep the pedal
pressed
during
the
adjustment
of
clamp's
sequence.
Proceed in the same way for the other horizontal clamp.
The moulding must be installed with the rebate facing to the blades.
The 2 horizontal clamps (PH) must be set so the extremities (EB) are at about 1 cm from
the moulding.
Keep the pedal pressed.
3)
Unlock the handle (
, then move the clamp assy (5) so its extremity (
position on the moulding. Release the pedal and check that the rubber (
moulding firmly without causing it to tilt.
The back of the moulding must be against the cutting guide
be flat on the table. It is important to make sure the moulding is locked in a stable
position during the cut. Repeat same sequence for the other vertical clamp.
5.B.a
Setting the horizontal clamps
Figure 5-5
5.B.b
Setting the vertical clamps (optional)
(6) and the moulding must
Still
with
the
pedal
pressed,
unlock
the
(M2) handle and adjust
the
position
of
the
horizontal clamps (PH)
to the contact of the
moulding,
then
backwards of 1 cm to
allow easy loading of
the moulding.
B1)
is in a stable
B1)
will hold the
CS940
PH
M2
Figure 5-6
EB
Figure 5-7
3
5
6
B1
Figure 5-8
25
Publicité
Table des Matières
