Standard Mode - SKF TKRS 41 Mode D'emploi

6.2.2 Standard mode

N O T E :
Not all of the settings shown in ig. 2 are available in
standard mode.
No. Position of the
selector switch (E)
OFF
4. FREQUENCY
How to select frequency:
1. Turn the selector switch (E) to the "FREQUENCY" position.
→ The following will then appear in the display for a few seconds:
•
all settings followed by
•
"S" for standard mode
→ The following will then appear in the display:
1. BRIGHT
Brightness (BRIGHT in deg)
Flash duration. This function allows the lash duration to be adjusted, which inluences the brightness and focus of the
object being viewed. In the standard mode, this setting can only be made in relative form (degrees), whereas the pro
mode also features the additional setting of measuring brightness in absolute form (microseconds).
(† ig. 2)
Display
–
Adjustable Description
parameters
Device is switched off
FPM Frequency selection:
FPM: lashes per minute
– Turning the knob while
pushing it simultaneously,
the adjustment increment is
effected in steps of 100.
– The lash can be turned off by
pushing the knob once and
turned on again by pushing the
knob once again.
2. Select the desired frequency using the
rotary/push knob (D).
þ
This setting is now active.
BRIGHT deg Selection of brightness
(in 1/1 000 degrees)
EN 11