SKF TKRS 41 Mode D'emploi page 16

6.2.3 Pro mode
(† ig. 2)
N O T E :
Follow the steps below to access the pro mode:
► Turn the selector switch (E) from "OFF" to
the required position whilst simultaneously
holding the rotary/push knob (D) until the "Pro"
notiication appears in the display.
þ The following will then appear in the display:
"Pro" for pro mode.
No. Position of the
selector switch (E)
OFF
4. FREQUENCY
1. BRIGHT
3. MENU
10. MENU
14 EN
N O T E :
If pro mode is activated, a "P" will be shown in the
bottom right area of the display.
N O T E :
If you have selected settings in pro mode and then
switch the device off, these settings will ONLY be
active when the device is switched back on if pro
mode is activated. Otherwise, only the standard
mode settings will be active.
Display
–
N O T E :
† section 6.2.2
explanations regarding above mentioned display
messages.
Adjustable Description
parameters
Device is switched off
FPM Frequency selection:
FPM: lashes per minute
– Turning the knob while
pushing it simultaneously,
the adjustment increment is
effected in steps of 100.
– The lash can be turned off by
pushing the knob once and
turned on again by pushing the
knob once again.
BRIGHT deg.: Selection of brightness
0,025° ... 3,0° (in 1/1 000 degrees)
BRIGHT μs: Selection of brightness unit in
1 ... 2,0 μs microseconds.
PHASE deg.: Delay setting between the trigger
0 ... 359 signal and lash (in degrees,
relative to the frequency)
Position ixed; actual delay
depending on current frequency.
INT / EXT Internal / external trigger
– "Standard mode" for examples and