MRA 4025066163311 Instructions De Montage page 4

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
1 Pair of retaining plates
4 Elastic nuts M5
4 Plastic discs 12x5x0.5mm
4 Lens head screws, M5x16mm
2 Distance sleeves M6, 7mm
2 Hexagonal cheese-head screw M6x40mm
2 Allen screws M6x20mm
2 Washers 12x6x1mm
4 Washers, black, 16x8x1mm
1 MRA-sticker, round
1 Edge protection strip with clamping sleeves
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface. Attach the round MRA sticker to the panel as shown in
picture A.
2. Remove the 4 original Allen screws from the headlight mask.
3. Put the Allen screw provided, M6x40mm [11016], together with the 12x6mm washer [10559],
through the front hole of the retaining plate and push the plastic spacer [11343] onto the screw
from below (P1).
4. Insert the provided M6x20 Allen screw [10662], together with the 12x6mm washers [10559] through
the rear hole of the retaining plate.
5. Mount the retaining plate on the motorcycle and insert the provided elastic nuts [10692] onto the
retaining plates (P2).
6. Mount the MRA windshield on the retaining plates with the provided neoprene washers and the
M5x16mm rounded head screws [10554].
7. Hoist the edge protection profile up onto the rear exposed area of the windscreen, starting from the
fillet and going to the opposite side. Cut off the rest if required. Push the clamping sleeves over the
ends of the protective edge strip and lightly compress them, using a pair of pliers to secure the edge
strip.
8. Now remove the lateral Allen screws from the lamp cover.
9. Plug the provided 16x8mm washer [11036] onto the Allen screw (P3).
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
MO UN T IN G IN STR UC T ION S
YAMAHA MT 07 2018-
Article No..
--- Allen key 3mm and 5mm
11342
10629
10635
10554
11343
11016
10662
10559
11036
11349
---
Required tools