dji MATRICE 200 Série Guide De Démarrage Rapide page 6

Mounting the Datalink Pro Air System to the Remote Controller
For the M200 series, only mount the Datalink Pro Air System to the
M210 RTK remote controller.
M3×5
Remove the screws.
M2.5×6
Attach the clips onto the
mounting board, then connect
the antennas to the Datalink Pro
Air System.
Using the Remote Controller
The Stick Mode is set to Mode 2 by default. In Mode 2, the left stick controls the aircraft's elevation and heading, and the
right stick controls the aircraft's forward, backward, and lateral movements. To adjust the FPV camera, press and hold the C2
Button and rotate the left dial.
Left Stick
For more information about how to connect and use the remote controller, please refer to the user manual.
You can change the stick mode and customize the C1-C4 and BA-BH buttons' functions in the DJI GO 4 app.
Affix the Datalink Pro Air System
onto the mounting board with
the double-sided adhesive, then
attach the mounting board onto
the back of the remote controller.
M3×12
1/4"
Affix the CAN Hub module to the
mounting board with the double-sided
adhesive, then secure the mounting
board using screws.
Right Stick
M2×8
Thread the Datalink Pro antennas
through the clips. Make sure that
the lines of the antennas lie in the
grooves of the mounting board
where the clips attach to prevent the
antennas from being damaged.
FPV Camera
5