dji MATRICE 200 Série Guide De Démarrage Rapide page 9

5. Flight
Toggle the Flight Power on the remote controller,
Mode switch to monitor, aircraft, and D-RTK
P-mode, the safest Ground System.
flight mode.
Inside the DJI GO 4 App
Auto Takeoff Auto Landing
These icons are for reference only. Icons in the DJI Pilot app may be different than icons in the DJI GO 4 app.
Watch the tutorials in the DJI GO 4 app or on the official DJI website to learn more.
Always set an appropriate RTH altitude before takeoff. Please refer to the Disclaimer and Safety Guidelines for more details.
Manual Takeoff
Use the Combination Stick Command to
start/stop the motors.
Return-to-Home (RC)
Pressing the Return to Home button on the remote controller brings
the aircraft back to the Home Point, just like the icon in DJI GO 4.
Press and hold the button to initiate the RTH procedure. Press it
again to cancel RTH.
To stop the motors mid-flight, press the RTH button while simultaneously pulling the left stick to
the bottom inner corner and hold for three seconds. Only stop the motors mid-flight in emergency
situations when doing so may reduce risk of damage or injury.
Rotating propellers can be dangerous. DO NOT start the motors in narrow spaces or when there
are people nearby. Always keep your hands on the remote controller while the motors are spinning.
After landing, power off the aircraft before turning off the remote controller.
8
Return to Home (RTH)
Or
DJI GO 4 Ready to Go (GPS)
App
Before taking off, ensure that the Aircraft Status Bar in the
Launch the DJI
DJI GO 4 app reads 'Ready to Go (GPS)' or 'Ready to Go
GO 4 app and
(Vision)' if flying indoors.
tap GO FLY.
Gimbal Working Modes
Push the left stick up
(slowly) to take off.
Intelligent Flight Modes
Manual Landing
Pull left stick down
(slowly) until you touch
the ground. Hold it for
a few seconds to stop
the motors.
It is important to understand basic
flight guidelines for the safety of both
you and those around you. Please
refer to the Disclaimer and Safety
Guidelines for more information.
No Fly Zones
Learn more:
http://flysafe.dji.com/no-fly