Vetus ILTCONF38 Instructions D'installation Et Mode D'emploi page 14

2 3 Fitting the connection cover
Clean the inside of the tank before fitting the
connection cover
• Fuel suction line (1)
Make the suction pipe to the correct length
- the bottom must be about 6 mm from the
bottom of the tank and place the suction
pipe on the connection.
• Fuel return line (2)
Make the return pipe to the correct length
- the underside must be about 6 mm from
the bottom of the tank - and place the suc-
tion pipe on the connection.
Make sure the right-angled connections are
facing away from each other.
14
040110.01
A
1
2
ca. 7 mm
vetus® Connection kit for fuel tanks
A + 5 mm