Fitting The Accessories - Invacare ScanBed 750 Manuel D'utilisation

5. Fitting the accessories

The tools necessary for mounting/dismounting the accessories of the SB750
adjustable wrench. The Allen key is kept on the inside of the cross bar at the head end of the top frame.
The Allen key is used for mounting/dismounting all fittings.
Mounting the mattress retainer
Mattress retainer is
squeezed down over the
mattress frame.
Mounting the bed end fittings
(If fittings have not been mounted in the factory)
1. Mount the 2 small fittings at the head end and tighten
them with the Allen key.
2. Mount the large fittings and the welded fitting at the
foot end and tighten them with the Allen key.
Mounting the PIGGY and ODA bed ends
Press the bed end into the U-profiles.
Mounting the FLEX III/KARIN III bed ends
Fasten the bed end to the bed end fittings with the bolts and tighten them with the Allen key.
Mounting the SANNE III bed end
Lift the bed end and place on the fittings at both sides. Push down to click into
place.
The locking pin must then be rotated and locked into postion.
Make sure that the bed end is locked.
Dismounting the SANNE III bed end
Pull the locking pin out, and turn it halfway.
Repeat at the other end. Pull the bed end up and out.
Mounting/dismounting the steel side rail
Mounting: Referring to labelling on the side rail
Tighten the side rail with 2 finger screws.
Dismounting: Loosen the finger screws, and remove the steel side rail.
To be placed between third and
fourth lamella on backrest.
13
TM
are an Allen key and an
To be placed between third and
fourth lamella on leg section.