Invacare ScanBed 750 Manuel D'utilisation page 11

Mounting the BRITT II/III/IV side rail
1. Raise the bed about 1/3.
2. Remove the protective tape from the locking pins at the ends of the side rail.
3. Mount one end at a time. Lift the lower wooden bar and guide the metal
bow to the bed end rail (A).
4. Press the locking pin of the side rail with a finger (B).
5. Guide the side rail to the bed end until the spring support snaps into place
and prevents the side rail from falling out of the bed end.
Repeat points 3 to 5 when mounting the other end of the side rail.
Dismounting the BRITT II/III/IV side rail
1. Raise the bed about 1/3. Lower the side rail.
2. Dismount one end at a time. Lift the lower wooden bar so that the spring support is visible.
3. Press the spring support down with a wrench or a screwdriver (C).
4. Hold the lower wooden bar. Lower the side rail, until the metal bow is free of the bed end rail.
Repeat points 2 to 4 when dismounting the other end of the side rail.
A
Fitting the lifting pole
Remove the plastic stopper in the lifting pole tube
in which the lifting pole is to be mounted.
Mount the lifting pole - the finger screw must be used.
Fitting the bumper wheel
Mount the bushing in the bumper wheel - and tighten it with a screw under the fitting.
Bumper wheels may not be mounted on SANNE bed ends.
Mounting the limitation crossbar under the leg section
If the bed is used by restless (spasms) or confused persons a limitation cross bar installed under the
leg section of the mattress support. This cross bar will prevent the leg section from being lowered be-
low the level ofthe mattress support, thereby reducing the opening between leg section and bed end.
Raise the leg section of the mattress support and the lifter arm, and mount the limitation crossbar.
Tighten both screws.
The limitation crossbar is placed here
B
Lifting pole
tube with
plastic stopper
Finger screw
The screws are tightened
14
C
Correctly mounted crossbar